Featured
2014 Silverado Anti Theft Reset
2014 Silverado Anti Theft Reset. During this time, it's recommended that you test your battery using a multimeter. The troubleshoot and reset procedures are different for each.
6 steps to reset the silverado antitheft system from the outside. Diy deterrent system device light reset, service deterrent system reset gmc chevrolet cadillac etc silverado tahoe suburban yukon escalade sierra savanajoin. Then put the key back in.
Remove The Key From The Door, Get Into Your Ford, And Start The Engine.
If it has gone off, then turn the key back to the off position and remove the key. Do this again, but turn the key in the opposite direction. The passlock iii system uses a transponder located under the plastic covering of the key.
Reconnect It And Make Sure That Both The Anode And Cathode Terminals Are Tightly Attached.
7 call an auto locksmith or repair shop. Leave the car with the ignition turned on for ten minutes. Passlock seems to have the highest failure rate.
The Contact Veered To The Shoulder Of The Road Turn The.
Wont start 2014 silverado 1500. Turn the key off, and wait five seconds. An antenna located at the entry point of the ignition lock cylinder reads the transponder data from the key and sends a code to the passlock control module.
Wait For A Couple Of Minutes To Make Sure That The System Reset Is Finished.
7 call an auto locksmith or repair shop. 4 how to turn off anti theft light on chevy silverado. Pop the hood of your truck to remove the battery.
Hold The Key For 30 Seconds In The Position.
If the resistance value read by the tdm is what the tdm is expecting, the tdm will send a signal to the pcm informing the pcm that a valid key is present and the pcm may start the vehicle. Put the ignition key into the keyhole. It will reset the computer system and your car is likely to kick off.
Comments
Post a Comment